Section 27-795
§ 27-795 High pressure boiler operating engineer license. If a boiler
produces steam or vapor or has a safety valve setting of more than
fifteen psi and rated in excess of ten hp. or if such boiler produces
hot water at a pressure of more than one hundred sixty psi or at a
temperature over two hundred fifty degrees Fahrenheit, such boiler shall
be operated by a high-pressure boiler operator licensed in accordance
with the requirements of subchapter two of title twenty-six of the
administrative code.
Section 27-796
§ 27-796 Oil burning equipment installer license. All oil burning
installations, including storage equipment, shall be made by, or under,
the direct supervision of a licensed oil burning equipment installer, in
accordance with requirements of subchapter two of title twenty-six of
the administrative code.
Section 27-797
§ 27-797 Certificates. No oil burning equipment hereafter installed
shall be operated until an equipment use permit has been issued by the
commissioner, the requirements of the air pollution control code have
been met as provided in section 27-799 of article four of this
subchapter, and until approval for the storage of fuel oil has been
given by the fire commissioner, except that temporary operation may be
permitted as provided in section 27-188 of article eighteen of
subchapter one of this chapter.
(a) Every oil burning installation that is not fully automatic or
requires preheating shall be operated by, or under, the direct
supervision of a person holding a certificate of fitness issued by the
fire commissioner. Such person shall be in the building at all times
while the burners are in operation, and shall be present in the boiler
room during the starting of the operation of a boiler.
Section 27-798
§ 27-798 Operators inspection after repairs. After any repairs are
made to a boiler or fuel burning equipment for which licensed or
qualified operators are required, such operators shall check the
repairs, together with the functioning of all controls devices and the
positioning of all valves. These licensed or qualified operators also
shall be present during the starting of the operation of the equipment
and shall be responsible for the proper and safe operation of such
equipment.